Concrete scanning is the most essential technologies for building contractors digging up a house construction site, because it helps them track down and get away from problem areas that can induce work slowdowns or maybe shutdowns. Also known as ground penetrating radar (GPR), this kind of solutions works on the radar that will gives off short jolts of radio wave pulses to see if there is any obstructions in the underground part. The presence of an obstruction is shown whenever an echo is read and also the depth where it is positioned can be determined by how long echo takes to send back along with the intensity on the signal.
Concrete scanning is often employed for the following applications:
Even so, GPR innovation does have its boundaries, one of the most major of which is that it can not work also in some types of land surface, such as wet clay that soil that has been greatly afflicted by salt.
Prior to site undergoes concrete scanning, there are certain things you should do to organize it to allow you to get essentially the most accurate effects from GPR.
Contact CSI Concrete Scanning and Investigations before you drill, cut or core concrete. For work place safety and to keep your project from costly down time, concrete scanning is essential.
Concrete scanning is often employed for the following applications:
- Diagnosing leaks in water pipes. It can be hard to look for leaking in lines running under concrete slabs and never have to investigate slab. By using GPR, you can easily know if there is drip and the place where it is so plumbing engineers will start digging in that section. Unknown and then unrepaired leakages can result in exorbitant water expenses in addition to major damage to property.
- Finding power pipes. One of the biggest risks within building construction sites is the fact that you´ll accidentally dig into underground power lines, resulting in damage that may cause lots of money to refurbish. GPR enables you to determine areas where there are power lines to enable them to be avoided.
- Distinguishing soil structure. GPR could review the structure of the ground where structure is to be built, to be sure structural reliability and get away from later complications, just like the base suddenly going down because of the soil is too soft to take its weight.
Even so, GPR innovation does have its boundaries, one of the most major of which is that it can not work also in some types of land surface, such as wet clay that soil that has been greatly afflicted by salt.
Prior to site undergoes concrete scanning, there are certain things you should do to organize it to allow you to get essentially the most accurate effects from GPR.
- Get rid of all clutter from the area to be read, because this can affect the radar and alter the final results.
- Determine substitute places to be examined in the event the initial section turns out to be not fit.
- Make certain that the ground is dried out just before having it scanned, as liquid reflects radar signals and therefore, radar would give undependable effects.
- If you are using the radar in order to identify underground conduits, switch on all the circuits as higher current conduits are simpler to discover as compared to low voltage ones.
Contact CSI Concrete Scanning and Investigations before you drill, cut or core concrete. For work place safety and to keep your project from costly down time, concrete scanning is essential.
RSS Feed